Please click here for instruction on setting
up Windows 98.
Please click here for instruction on setting
up Windows 95
Please click here for instruction on modifying
the Windows 95/98 Setup Boot disk for use on FutureMate™. |
||||||
|
|
||||||
|
Along
with the system you may have received either a driver CD or Diskette.
Use appropriate media when indicated.
|
||||||
|
|
||||||
| Suspend
to Disk Partition (Windows 95/98) 1. Copy the file d:\s2d\0vmakfil.exe to a bootable disk, where d: is the CD-ROM drive. 2. Boot up from the bootable DOS disk. 3. From a:\, type 0vmakfil -pXX, where XX is at least the amount of system memory installed plus 2 MB for video RAM. Recommended parameter:- p100. Return to top |
||||||
|
|
||||||
| Core
Logic Driver for Intel Chipset (Windows 95 only) 1. See instructions for installing USB Supplement. 2. From the Utility CD, run d:\setup, where d: is the CD-ROM drive. 3. After the system reboots, several "New Hardware Found" prompts will appear. Do not restart until Windows Desktop appears. 4. During hardware detection, Setup will prompt you for Audio device drivers. Enter "d:\audio\95" as the location of the driver. 5. When you are asked for drivers for the gameport joystick, just use the Windows default driver. 6. Setup will continue. Select English as desired language. 7. PCMCIA wizard will start. Answer No to the two questions, then select Finish and reboot the system. Return to top |
||||||
|
|
||||||
|
AUDIO
(Windows98/95) |
||||||
|
|
||||||
| VIDEO Windows 95 / 98 1. Go to Control Panel / Display / Settings / Advanced Properties 2. In the Adapter click on Change. 3. Enter D:\vga\95 as the path. Select Trident 9660/9680/938X, Linear Accelerator for PCI (v.5.00.10.TW.1403) 4. Click on Monitor/Change. Select Show All Devices, and select Laptop Display Panel 800x600. Click on Close to return to the Settings screen. 5. Move the Desktop Area slider right to 800x600, and check the box for Show settings icon on task bar. Then, click on Apply. Restart Windows when prompted. Windows NT 4.0 1. From Control Panel, select Display / Settings / Display Type / Change / Have Disk / d:\drivers\vga\nt40 2. Select Trident Video Accelerator (#11044 11/07/97) 3. Click on OK to return to Display Properties, and OK again to restart Windows NT. 4. After Windows NT restarts, go to Control Panel / Display Properties. 5. Set Desktop Area to 800x600. Select Test to test the configuration, and then Apply. Return to top |
||||||
|
|
||||||
| PCMCIA
(Windows98) Windows 95 Please see Core Logic Setup for installation of pcmcia driver. Return to top |
||||||
|
|
||||||
|
Universal
Serial Bus Windows 95 1. Insert the Windows 95B CD-ROM with USB Supplement. 2. From the Start menu, run d:\other\usb\usbsupp.exe. 3. Scandisk will start. After it finishes, allow it to shutdown and restart Windows. 4. When asked to insert the Windows 95 CD-ROM or the location of uhcd.sys, type in C:\Windows\System as the path. 5. Continue with Core Logic Setup to set up other devices. Return to top |
||||||
